Avery Dennison Pathfinder 6057 LNT Programmer Manual using XML - Manual (Page 16)

2-2 LNT Programmer’s Manual
Example
Defines the label size as 1.0 inch long by 2.0 inches wide.
Defining the Ene rgy Tag (Optional)
The Energy tag defines the printhead energy level. You may need to adjust this value
depending on the type of supplies you are using. For example, synthetic supplies require the
High energy setting, but standard paper does not.
Valid values include: Normal (0) and High (1). The default is Normal.
Syntax
value
Example
High
Sets the printhead energy to high for synthetic supplies.
Defining the Contrast Tag (Optional)
The Contrast tag defines the print contrast for the job. You may need to adjust this value
depending on the type of supplies you are using. For example, synthetic supplies require a
higher print contrast, but standard paper requires less contrast.
Note: Solid black print should not exceed 30% on a given square inch of the label, or the
printhead life may be decreased.
Valid values include: -100% (minimum contrast) to 100% (maximum contrast). The default
is 0 (no contrast adjustment).
Syntax
value
Example
35
Sets the print contrast to 35% for this job.
Defining the PrintSpeed Ta g (Optional)
The PrintSpeed tag defines the print speed in inches per second (ips) for the job.
Valid values include: a float in the range of 1.0 to 5.0.
It contains the following attribute: fixed.
Note: Serial bar codes, lines, and graphics print at 2.0 ips. Synthetic supplies and special
supplies print at 1.5 ips.
Syntax
value
Fi xed The printer prints at the s pecified setting until the battery drains. Options:
0 False (default)
1 True
Note : Fi xed can be enabled for speeds 3.0, 4.0 and 5.0 ips. Fi xed is only recomm ended for
te xt formats, whe re print speed is required over pri nt quality.
Example
5.0
Sets the printer’s speed to 5.0 ips, but allows the speed to vary from 5.0 ips for serial bar
codes, etc.