Artesyn MOTLoad Firmware Package User's Manual (February 2015) - Manual (Page 46)

MOTLoad Commands
MOTLoad Firmware Package User’s Manual (6806800C24D) 46
3.1.6 blkCp
Name
blkCp—copies the number of blocks, specified by the user, from the device to the destination
device. This command only operates on ’block devices’.
Synopsis
blkCp -a -b [-n] [-s]
Parameters
-a Ps: Device Name of Source
-b Ps: Device Name of Destination
-n Ph: Number of Blocks (Default = 1)
-s Ph: Starting Block Number (Default = 0)
Example
The following example shows a typical result of entering the blkCP command:
MOTLoad> blkCp -a/dev/ide0/hdisk0 -b/dev/ide0/hdisk0 -n200
Error Messages
blockCopy(): malloc(0x20000) failed
Unable to malloc a local buffer of 128 KB.
blockCopy(): open() failed, errno =
Unable to open source/destination device/node.
blockCopy(): ioctl(103) failed, errno =
Unable to retrieve the physical block size of the source/destination device.
blockCopy(): bseek() failed, errno =
Seek to desired block (starting block of transfer) on source/destination.