96 testrambounce, Testrambounce, Motload commands – Artesyn MOTLoad Firmware Package User's Manual (February 2015) User Manual

Page 184

MOTLoad Commands

MOTLoad Firmware Package User’s Manual (6806800C24D)

184

3.1.96 testRamBounce

Name

testRamBounce—writes all ones to all memory addresses within the default or specified
memory block, then performs a read-back and verify of each memory address. If a mis-
compare is detected, an error is logged. This operation is repeated a second time but the write
data is all zero.

Note: testRamBounce only test memory in blocks, thus specifying a memory area size that is
not a multiple of the block size results in part of the memory area being untested.

Synopsis

testRamBounce [-a] [-b] [-i] [-n] [-t] [-v]

Parameters

-a Ph: Address to Start (Default = Dynamic Allocation)

-b Ph: Block Size (Default = 16 KB)

-i Pd: Iterations (Default = 1)

-n Ph: Number of Bytes (Default = 1 MB)

-t Pd: Time Delay Between Blocks in OS Ticks (Default = 1)

-v 0: Verbose Output

Example

The following example indicates a typical display when using the testRamBounce command.

MOTLoad> testRamBounce -v

Executing RAM Bounce: PASSED