Artesyn MOTLoad Firmware Package User's Manual (February 2015) - Manual (Page 21)

Introduction
MOTLoad Firmware Package User’s Manual (6806800C24D) 21
A listing of all device path strings can be displayed through the devShow command. If a SBC
device does not have a device path string it is not supported by MOTLoad and can not be
directly tested. There are a few exceptions to the device path string requirement, like testing
RAM, which is not considered a true device and can be directly tested without a device path
string. Refer to the devShow command page in this manual for more information.
Most MOTLoad tests can be organized to execute as a group of related tests (a test suite)
through the use of the testSuite command. The expert operator can customize their
testing by defining and creating a custom test suite(s). The list of built-in and user defined
MOTLoad test suites, and their test contents, can be obtained by entering: testSuite –d at
the MOTLoad prompt. All test suites that are included as part of a product specific MOTLoad
firmware package are product specific. For more information refer to the testSuite
command page in this manual.
Test results and test status are obtained through the testStatus, errorDisplay, and
taskActive
commands. Refer to the appropriate command page(s) in this manual for more
information.