AMETEK SLM Series Rev B - Manual (Page 7)

Important Safety Instructions
Before applying power to the system, verify that your product is configured properly for your
particular application.
WARNING
Hazardous voltages may be present when covers are removed.
Qualified personnel must use extreme caution when servicing this
equipment. Circuit boards, test points, and output voltages also may
be floating above (below) chassis ground.
Only qualified personnel who deal with attendant hazards in power supplies, are allowed to
perform installation and servicing.
Ensure that the AC power line ground is connected properly to the Power Rack input connector or
chassis. Similarly, other power ground lines including those to application and maintenance
equipment must be grounded properly for both personnel and equipment safety.
Always ensure that facility AC input power is de-energized prior to connecting or disconnecting
any cable.
In normal operation, the operator does not have access to hazardous voltages within the chassis.
However, depending on the user’s application configuration, HIGH VOLTAGES HAZARDOUS
TO HUMAN SAFETY may be normally generated on the output terminals. The customer/user
must ensure that the output power lines are labeled properly as to the safety hazards and that
any inadvertent contact with hazardous voltages is eliminated.
Guard against risks of electrical shock during open cover checks by not touching any portion of
the electrical circuits. Even when power is off, capacitors may retain an electrical charge. Use
safety glasses during open cover checks to avoid personal injury by any sudden component
failure.
SAFETY SYMBOLS
iii