AMETEK SLH Series RevB - Manual (Page 74)

Appendix D Sorensen SLH-Series AC High Power Electronic Load
D-4 M540073-01 Rev C
The following connections should be made with power disconnected from the load.
Load Input for 30Arms and Greater Systems
Use cables to parallel positive terminals on the rear panel (positive is located on the right
as you face the rear panel), and to parallel all negative terminals (negative is located on
the left as you face the rear panel). Refer to Figure 2. Wire the system Positive and
Negative (+ and -) load input, from any open terminal blocks.
Note: For systems rated at 30Arms and lower, the rear terminals are not present.
WARNING