AMETEK SLH Series RevB User Manual
Page 47
SLH-Series AC High Power Electronic Load
GPIB/RS232 Programming Operation
M540073-01 Rev C
4-5
COMMAND NOTE
RETURN
[SYStem:] RECall{SP}{m[,n]}{;|NL}
M=1~5 n=1~30
[SYStem:] STORe{SP}{m[,n]}{;|NL}
M=1~5 n=1~30
[SYStem:] REMOTE{;|NL}
Only RS232 cmd
[SYStem:] LOCAL{;|NL}
Only RS232 cmd
0=:OFF, 1=:ON
[SYStem:] NAME{?}{;|NL}
“XXXXX”
Table 4-7 System Commands
COMMAND RETURN
MEASure:CURRent {?}{;
⎢NL}
###.####
MEASure:VOLTage {?}{;
⎢NL}
###.####
MEASure:PWR {?}{;
⎢NL}
###.####
MEASure:VA {?}{;
⎢NL}
###.####
LIM:CURRent:{HIGH|LOW
}{SP}{NR2}{;|NL}
LIM:CURRent:{HIGH|LOW
}{?}{;|NL}
###.####
LIM:POWer:{HIGH|LOW
}{SP}{NR2}{;|NL}
LIM:POWer:{HIGH|LOW
}{?}{;|NL}
###.####
LIM:VA:{HIGH|LOW
}{SP}{NR2}{;|NL}
LIM:VA:{HIGH|LOW
}{?}{;|NL}
###.####
LIM:VOLTage:{HIGH|LOW
}{SP}{NR2}{;|NL}
LIM:VOLTage:{HIGH|LOW
}{?}{;|NL}
###.####
Table 4-8 Measure and Limit Commands
COMMAND RETURN
GLOBal:[STATe:] PRESet{SP}{ON|OFF}{;|NL}
GLOBal:[STATe:] LOAD{SP}{ON|OFF}{;|NL}
GLOBal:[STATe:] MODE{SP}{ON|OFF}{;|NL}
GLOBal:[STATe:] LEVEL{SP}{A|B}{;|NL}
GLOBal:MEASure:CURRent{?}{;|NL} ###.##
GLOBal:MEASure:VOLtage{?}{;|NL} ###.##
Table 4-9 Global Commands
REMARKS:
1. d : 0 - 9
2. GLOB : GLOBAL (ALL CHANNELS ACTIVE AT SAME TIME)
3. CURRENT ENGINEERING UNIT : A
4. VOLTAGE ENGINEERING UNIT : V
5. RESISTANCE ENGINEERING UNIT :
Ω
6. PERIOD ENGINEERING UNIT : mS
7. SLEW-RATE ENGINEERING UNIT : A/
μS
Note: The RS-232 command set is the same as the GPIB command set.