AMETEK SLH Series RevB - Manual (Page 43)

M540073-01 Rev C 4-1
SECTION 4
GPIB/RS-232 PROGRAMMING
OPERATION
4.1 INTRODUCTION
The rear panel of SLH-series is designed for automated and/or remote testing from a
computer through a GPIB or RS-232 interface. This feature can be used as an
automatic load/cross load regulation and centering voltage testing for a switching
power supply or a rechargeable battery charge/discharge characteristic testing.
4.2 SLH-SERIES GPIB COMMAND LIST
4.2.1 Setting Commands
Function Command Format
SET AUTO FREQUENCY
DETECT ON/OFF AFREQ{SP}{0|1|OFF|ON}{;|NL}
SET SYNC ON/OFF SYNC{SP}{0|1|OFF|ON}{;|NL}
SET SENC ON/OFF SENS{SP}{0|1|OFF|ON}{;|NL}
SET WATT ON/OFF WATT{SP}{0|1|OFF|ON}{;|NL}
SET BANK BANK{SP}{d}{;|NL} d:0 ~ 10
SET WAVE WAVE{SP}{m}{;|NL}} m:1 ~ 5
SET FREQUENCY PREQ{SP}{NR2}{;|NL} NR2:###.#####
SET VOLTAGE LOW LIMIT VL{SP}{NR2}{;|NL}
SET VOLTAGE HIGH LIMIT VH{SP}{NR2}{;|NL}
SET CURRENT LOW LIMIT IL{SP}{NR2}{;|NL}
SET CURRENT HIGH LIMIT IH{SP}{NR2}{;|NL}
SET WATT LOW LIMIT WL{SP}{NR2}{;|NL}
SET WATT HIGH LIMIT WH{SP}{NR2}{;|NL}
SET VA LOW LIMIT VAL{SP}{NR2}{;|NL}
SET VA HIGH LIMIT VAH{SP}{NR2}{;|NL}
SET CURRENT CURR:{LOW|HIGH|A|B}{SP}{NR2}{;|NL} NR2:###.#####
SET RESISTANCE RES:{LOW|HIGH|A|B}{SP}{NR2}{;|NL}
SET LOAD ON/OFF LOAD{SP}{0|1|OFF|ON}{;|NL}
SET LEVEL LOW/HIGH LEV{SP}{0|1|LOW|HIGH}{;|NL}
SET PRESENT ON/OFF PRES{SP}{0|1|OFF|ON}{;|NL}
SET MODE MODE{SP}{0|1|2|CC|CR|CV}{;|NL}
SET CLEAR STATE CLER{;|NL}
SET STORE STATE STORE{SP}{m}{;|NL} m:1 ~ 5
SET RECALL STATE RECALL{SP}{m}{;|NL} m:1 ~ 5
Table 4-1 GPIB Setting Command Summary