AMETEK SLH Series RevB - Manual (Page 69)

M540073-01 Rev C C-1
APPENDIX C
SETTING THE AC OR DC ELECTRONIC LOAD
The SLH-series High Power AC/DC Electronic load is a full function electronic load for AC
and DC. The setting of electronic load for AC or DC depends on the output frequency of the
device under test (DUT). The setting is described as follows:
Setting of the AC Electronic Load
When SLH-series High Power AC/DC Electronic load is used for AC, the frequency of
SLH-series High Power AC/DC Electronic load must be set to the same frequency of the
DUT. Even if the output frequency of the DUT is 50 Hz, the frequency of SLH-series High
Power AC/DC Electronic load must be set to 50.0 Hz by means of the FREQ function.
Setting of the DC Electronic Load
When SLH-series High Power AC/DC Electronic load is used for DC, SLH-series High
Power AC/DC Electronic load must be set to DC. When the frequency is set to, the Bank
function is not available and will not be displayed on the monitor.