Appendix b - technical specifications, Base model (rd70-xx), Inputs – Adtec digital RD-70 (version 1.02.04) Manual User Manual
Page 61: Outputs, Appendix, Technical, Specifications, Base, Model, Inputs outputs

Appendix B - Technical Specifications
Base Model (RD70-XX)
Inputs
DVB-ASI
Use: Input available for Decode or Pass to ASI outputs.
Standard: Asynchronous Serial Interface per EN500083-9
Input Rates: DVB-ASI 210Mb/s for free-to-air 188/204/208 Byte Transport streams (SPTS and MPTS).
If TSO (TS Out Decrypt) option is OFF and transport stream contains BISS encrypted programs, up to
164Mb/s at this time. If TSO option is ON and transport stream contain BISS encrypted programs
(SPTS and MPTS), up to 120Mb/s. See TSO article in Chapter 3 for more information.
Connector: BNC (75 Ohm)
IP
Use: Input available for decode, but may also be used for control
Standard: MPEG 2 RTP v2 transport (RFC 3550)
Input Rates: 1 - 100Mbps (188 byte DVB packet size, 7 per IP packet)*
Standard: MPEG 2 UDP transport
Input Rates: 1 - 100Mbps (188 byte DVB packet size, 7 per IP packet)*
Standard: RTP SMPTE 2022-1 2007 FEC
Input Rates: 1 - 45Mbps (188 byte DVB packet size, 7 per IP packet)*
Connection speed: GigE (100/1000BaseT)
*Supported bandwidth decreases with streams that have not been created with 7 DVB packets per IP
packet. 1 DVB Packet per IP Packet does not utilize the same data efficiency / throughput as 7. The
amount of DVB packets per IP payload is a multicast transmitter configuration and is automatically
detected by the receiver. To utilize full IP receive throughput, use of the GigE port with packetization
of 7 DVB packets per IP packet is recommended.
**The user has the ability to receive IP streams via the GigE or 10/100 management port. When
receiving streams via the 10/100 management port, throughput is limited.
Connector: 8 pin RJ45
RF (optional)
Use: Input available for decode.
Standard: DVBS & DVB-S2 QPSK/8PSK with 16APSK and 32APSK options available.
188/204/208 byte packet size
Connector: Two Female F connectors (75 Ohm)
Outputs
3G-SDI / HD-SDI / SD-SDI
Two banks (two mirrored SDI outputs per bank) of SDI Outputs from Decoder
Standard: Video & Audio SMPTE 259M - SD, SMPTE 292M - HD, SMPTE 424M - 3G
Up to 16 Channels of Embedded audio
SDI Ancillary support for Closed Captioning, AFD and Teletext
- signEdje (version 02.07.09) Quick Start mediaHUB-HD 422 (version 1.01.10_M_2) Quick Start mediaHUB-HD Pro (version 03.07.19) Quick Start YUV2QAM (version 01.02.01) Quick Start EN-30 (version 1.02.02) Quick Start EN-81 (version 2.02.28) Manual EN-80 (version 2.02.28) Manual EN-100 (version 2.00.31) Manual EN-91 / EN-91P (version 1.02.29) Manual RD-60 (version 1.13.02) Manual