Adtec digital RD-70 (version 1.02.04) Manual - Manual (Page 22)

and REMOTE is used in standard
genlock operation. signal
REMOTE - Enable genlock, Decode
source is NOT synchronous to SYNC
IN signal
Horizontal
Adjust
Horizontal adjustment defines
the difference in the SYNC IN
HSYNC and output HSYNC.
Typically, this should be in the
range of 0 to +1 line in clocks.
For example, a 1080I output
could be adjusted from 0 to
2200.
0 - 2200
Vertical Adjust Vertical adjustment defines the
difference in the SYNC IN VSYNC
and output VSYNC. Typically, this
should be in the range of 0 to +1
frame in lines. For example, a
1080I output could be adjusted
from 0 to 1125.
0 - 1125
Pixel Phase Pixel Phase adjustment is a very
fine grain adjustment that can
adjust within a single clock. The
increments are 1/64th of a clock.
The valid range is 0 to 63.
0 - 63
Genlock Status Shows if GENLOCK input is
currently being used for the
decoder or in FREE RUN mode
Genlock CVBS
Out This configuration is used
generally with 3D applications.
The ‘MASTER’ unit CVBS
configuration must be configured
as ‘SYNC’.
VIDEO - CVBS output is video
SYNC - CVBS output is black burst
sync signal
Genlock Reset Reinitializes the Genlock System.