Adtec digital RD-70 (version 1.02.04) Manual - Manual (Page 24)

DolbyD
Mode
Configures the audio engine to
Pass-through ( COMPRESSED )
or decode ( 2/0 STEREO ) if a
Dolby Digital AC3 PID is
detected for the selected Audio
input. Mpeg1Layer2 always
decodes, and LPCM / Dolby E
always Pass-through,
regardless of this setting.
Dolby Decode requires feature
key capability.
PASSTHRU (default)
DECODE - STEREO*
DolbyE Line This is used to configure Dolby
E placement in the SDI output
and is configurable per audio
engine. When set to AUTO (-
1), the default configuration,
the Dolby E line is placed
within the valid line number
range for the video resolution.
The Dolby E line may be
manually configured to a value
within range. Valid ranges for
Dolby E line placement are
resolution and frame rate
dependent. If the configured
value is not valid, the system
will use the valid line used by
the 'AUTO' mode. The Dolby E
line status information can be
used to see the actual Dolby E
line placement.
View Dolby E line table for
more information.
-1 - 4096
-1 = AUTO
Analog Vol.
Pair 1 & 2 Adjusts the analog volume of
the first pair in dB increments -49 - 18 dBu
SDI Audio
Matrix 1-8
SDI Audio
Matrix The SDI audio matrix allows
the user to route, duplicate, or
disable audio pairs within the
SDI embedded output.
DISABLE, Disable audio output on
selected SDI pair
AUTO, default, Invokes automatic SDI
pair assignment. This is the default
setting.
AUDIO1, Route Audio 1 to the selected
SDI pair
AUDIO2, Route Audio 2 to the selected