Adtec digital RD-70 (version 1.02.04) Manual - Manual (Page 21)

selected, the current device name
will be used.
3G Mapping
Level SDI
SDI 3G Level controls the
mapping of the 3G-SDI signal
when decoding 1080P50,
1080P59.94 and 1080P60
streams. The 3G-SDI signal can
be mapped to Level A or Level B
Dual Link. The mapping is
individually configurable for each
set of outputs (SDI and SDIALT).
If 3G-SDI output does not
appear on the downstream
device, the device may not
support the currently configured
mapping mode. Use SDI3GLEVEL
to change the mapping mode.
A
B
3G Mapping
Level SDIALT SDI 3G Level controls the
mapping of the 3G-SDI signal
when decoding 1080P50,
1080P59.94 and 1080P60
streams. The 3G-SDI signal can
be mapped to Level A or Level B
Dual Link. The mapping is
individually configurable for each
set of outputs (SDI and SDIALT).
If 3G-SDI output does not
appear on the downstream
device, the device may not
support the currently configured
mapping mode. Use SDI3GLEVEL
to change the mapping mode.
A
B
Downscaling
SDI
The Downscaling SDI setting
determines whether the SDI
bank ( SDI Output 1 and 2 ) will
be output natively or downscaled
to SD.
OFF
SD
Downscaling
SDIALT The Downscaling SDI setting
determines whether the SDI
bank ( SDI Output 3 and 4 ) will
be output natively or downscaled
to SD.
OFF
SD
Genlock Menu
Genlock Mode Configures the genlock operation
of the decoder. SLAVE is
primarily used for 3D applications OFF - Disables genlock
SLAVE - Enable Genlock, Decode
source is synchronous to SYNC IN