Adtec digital RD-70 (version 1.02.04) Manual - Manual (Page 20)

value is 300 milliseconds. If the timeout
value is set too low, the multicast receive
may timeout during normal reception if the
packet transmission is bursty.
Multicast Error
Recovery
Multicast Error Recovery sets the timeout
value for recovery of multicast receive after
decoder error condition is detected.
The default error recovery timeout is
configuration value is 10000 milliseconds.
33 - 600000ms
10000ms (default)
Video Menu
Item Function Options
Output Menu
Fault Mode Display or Modify the current SDI
video fault setting. This setting
sets the video resolution when in
video fault.
This setting will be applied on
startup when no video is present.
If video becomes present, the
setting will be overridden by the
current video setting.
480i59.94
576i50
720p59.94
720p50
1080i59.94
1080i50
1080p59.94
1080p50
Video Loss When video is not detected on
the configured input, this setting
will define the output.
OFF:No video output on fault
BLANK:Only blanking on fault
BLANKTONES: Blanking and tones
on fault
BLANKOVERLAY: Blanking and
overlay on fault
BLANKTONESOVERLAY
Blanking, tones and overlay
on fault
When a type with BLANK is selected,
the current bars/matte setting will
be applied.
When a type with TONES is
selected, the current tones setting
will be applied.
When a type with OVERLAY is