Adtec digital RD-70 (version 1.02.04) Manual - Manual (Page 18)

LNB Tone This control is used only for Universal LNB
applications. A universal LNB can route the high
or low band from either polarity to the IRD. The
high band is selected by enabling the 22 kHz
tone and the low band is selected when the 0 Hz
tone is enabled.
0KHz
22KHz
Modulation
Type Allows the selection of the mod type. AUTO
DVBS
DVBS-2
Symbol Rate The number of symbols transmitted per second.
The amount of data per symbol is dependant
upon the modulation type, e.g. QPSK, 8PSK, etc.
Set this field to 0 for automatic Symbol Rate.
0 = AUTO
Range can be determined by
feature key.
ISI ISI (input stream identifier) is required for
multistream applications. If a multistream RF
source is detected, BBHeaders containing this
value will be demodulated and output to the
receiver. This value has no effect during single
stream applications.
0 - 255
RF Stats
Menu
RF Stats General RF Lock Status is provided via the RF
quickview menu, but a detailed list of further
information can be found in this menu.