Adtec digital EN-30 (version 1.02.02) Manual - Manual (Page 54)

Conditional Access:
BISS 1/E
Transport Outputs:
All outputs operate concurrently.
ASI
Connector: BNC x2
ISO13818-1 MPEG 2 Transport Stream per EN 50083-9:1997 (188 byte only).
Both ASI outputs contain multiplexed output of both services (MPTS) if using 2 service model
Physical interface 150Mb/s with no encryption
Transport Over IP (TSoIP)
Connector: RJ45 x1 10/100/1000GigE
ISO13818-1 MPEG 2 Transport Stream per EN 50083-9:1997 (188 byte only).
UDP or RTP encapsulated routes
with SMPTE 2022 (COP3 FEC). MPTS or SPTS user definable.
Physical:
Operating Temp.: 0 to +50 °C/+32 to +122°F
Power Supply (nominal): 100 - 240 VAC
Power Consumption (nominal): 33.6 W (120V @ 280mA)
Weight: 6 lbs
Measurements: (H X W X D) 1.73” X 19” X 13.32”
Management:
Front Panel Controls
Browser-based Web Interface
SNMP
IF, L-Band Modulator + 10MHz (option) - IF/LB/10M-01
Requires factory installation
note*: software keys are required to unlock full hardware support.
Compliant standards supported: DVB-S (EN 300421), DVB-S2 (EN 302307) and DVB-S2X (DVB-S2
Extensions)
Modulation Scheme Support: QPSK / 8PSK / 16APSK / 32APSK / 64APSK
DVB-S QPSK FEC rates: 1/2, 2/3, 3/4, 5/6, 7/8
DVB-S2 QPSK FEC rates: 1/4, 1/3, 2/5, 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10
DVB-S2 8PSK FEC rates: 3/5, 2/3, 3/4, 5/6, 8/9, 9/10
DVB-S2 16APSK FEC rates: 2/3, 3/4, 4/5, 5/6, 8/9, 9/10
DVB-S2 32APSK FEC rates: 3/4, 4/5, 5/6, 8/9, 9/10
Interface Rate: 50 kbit/s- 150 Mb/s (modcod & interface dependent)
Baudrate range: 0.05 - 72 Mbaud. (modcod dependent)
Clean Channel Technology - Roll-off factors: 5%, 10%, 15%, 20%, 25%, 35% for all modulations
RF Carrier ID compliant
IF and L-Band outputs are not active simultaneously
IF Output
Output level: -35 to +5dBm (+/- 2dB)