Adtec digital EN-30 (version 1.02.02) Manual - Manual (Page 20)

recovery
TOS Type of Service helps define how
the network should make
negotiate queuing between
throughput, delay, reliability, and
cost. Normal
Minimize Cost
Maximize
Reliability
Maximize
Throughput
Minimize Delay *.ECMD0 TOS #
TTL Time to live is a numeric value
from 1 to 255 that specifies the
number of iterations or
transmissions the packet can
undergo before it is discarded.
The default value is 7. 1 - 255 *.ECMD0 TTL #
Multicast
Connector sets the physical connector (on
the rear of the unit) to use for
multicast transmit purposes on
the indicated encode channel. Ethernet
!GigE *.ECMD0 MCN #
Service Select Select both services or single
service transport stream ALL
ENC1
ENC2 *.ECMD0 MST #
Multi Mux Rate Configures the TMR of the IP
output.
Note:only usable in SPTS mode 0 - 150 Mb/s *.ECMD MMO #
Multi Mux Mode Configure Multi Mux Rate to auto
or manual mode Auto
Manual *.ECMD MMO #
Note: Four IP destinations are available on the product. The ‘#’ denoted in the IP Tx
Commands above are relevant to the four destinations indexed 0 - 3.
Video Menu
The following diagram illustrates the structure and flow of the Video Menu on the Adtec
EN-30 device:
Control Function Options API Command
Input Video Input designates the type of
video signal being received, either
SDI or Composite. If the input is
SDI, the encoder will automatically
detect the resolution and frame rate SDI
COMPOSITE *.ECMD# INP