Adtec digital EN-30 (version 1.02.02) Manual - Manual (Page 14)

spaces)
Service
Number The Service Number or Program Number in PAT
& PMT packets identifies which program is
associated with which Video & Audio PIDs. This
value should be entered in decimal format
1 - 65535
Logical
Channel
Number
This setting allows you to set the logical
channel number that will be used to tune in
with a set top box or television. This setting
is only valid with DVB table generation.
1 - 9999 *.ECMD# LCN
Bars,
Tones, ID
Menu
Bars, Tones and Service ID information can
be overlayed on top of valid video by
selecting the desired combination from this
menu.
Note: When an audio input / channel is
configured for Pass through operation
Internal tone generation does not function
for the pass through channels.
Bars Mode:
ON, OFF
Bars Type:
BARS, Solid
color,
FLASH
Tones
Mode: ON,
OFF
OSD Mode:
ON, OFF,
BLINK
Important: setting the Major Channel Number to zero (0) will equate to setting a single-part
channel number in ATSC applications.
RF Tx Menu
The following diagram illustrates the structure and flow of the RF Tx Menu on the Adtec EN-
30 device. This menu will not be available on units without the optional RF modulators.
Item Function Options
Transmit Allows the operator to
enable or disable the Main
RF output. If Transmit is
enabled and any value for
Type, Frequency, Rolloff,
Symbol Rate, or Interface
Rate is changed, then
Transmit will be
automatically disabled.
However, the monitor
output will remain active.
Disable
Enable
Type Allows the selection of the
mod type. DVBS
DVBS-2
Mode This control allows the We display all possible ranges available via