Adtec digital EN-30 (version 1.02.02) Manual - Manual (Page 19)

IP Tx Menu
The following diagram represents the structure of the IP Tx Menu Menu:
Control Function Options API Command
Mode switches multicast function on and
off Off
Send *.ECMD0 MMO #
Tx IP Address The IP Address of which the
Multicast or Unicast is broadcast.
Multicast addressing supports the
transmission of a single IP
datagram to multiple receivers.
Valid Multicast addressing range is
224.10.XXX.XXX to
239.XXX.XXX.XXX. Unicast
addressing sends a single IP
datagram to only one receiver.
The Unicast address will be the
unique IP of the receiving device. user-defined;
numeric field in
format
xxx.xxx.xxx.xx
x *.ECMD0 MSI #
Tx Port port assignment used for
transmitting a multicast user-defined;
numeric field *.ECMD0 MSP #
DVB per IP Configures the amount of DVB
transport stream packets ( 188
bytes per DVB packet ) per IP
packet payload.
1
4
7
*.ECMD0 MSY #
RTP Allows for sequence numbering
and timing for accurate playback. On
Off *.ECMD0 RTP #
FEC Mode Forward Error Correction; selects
on/off. When selected, sends two
FEC RTP streams in addition to a
source RTP stream enabling a
receiver to reconstruct missing
packets in the source stream.
The RTP Control (above) must be
set to 'on' to enable FEC. On
Off
Available if RTP
selected 'on' *.ECMD0 FEP #
FEC L affects the maximum burst packet
loss that can be recovered 4-20 *.ECMD FEP #
FEC D defines latency involved in burst 4-20 *.ECMD FEP #