Adtec digital EN-30 (version 1.02.02) Manual - Manual (Page 35)

Once you have the version you wish to use in the Installed Versions list, you can select into it
by clicking the select button. The unit will reboot and come up running in the new version.
Chapter 4 - How-To Guides
How to Complete a Manual Upgrade
You can upgrade your Adtec device's firmware via built-in web-based application, described
in the
Upgrade Tab section, or via a Telnet/FTP session, described in this article.
To update your Adtec device 's firmware via a Telnet session, perform the following:
Manual Upgrade Process
Step Action
1 Obtain the desired firmware version file from www.adtecftp.com
note*: Firmware releases are found in the Public Folders -> Firmware -> Release
-> section of the website, in a folder marked with the product name. username:
adtecftp password: adtecftp2231
note**: Windows Internet Explorer renames adtec firmware file extensions to .gz .
When saving please add a t within the extension to read .tgz if IE has renamed
your file.
2 Using your favorite FTP client to upload the firmware file to the device.
If you are unfamiliar with FTP you may use a 'My Computer' window and type in
the address bar, ftp://adtec:[email protected] where 192.168.10.48 should be
replaced with the IP Address of YOUR device. You may then drag and drop the
firmware file into the hd0 folder.
3 Open a Telnet session and enter the IP address of the unit you are going to
update.
note*: If you are unfamiliar with telnet, open a command prompt window
(windows: start -> run.., mac: macintosh hd -> applications -> utilities ->
terminal) and type: telnet 192.168.10.48
4 Enter the username as ' adtec ' and the password as ' none '.
5 Enter the following in sequence: *.ecmd stop
6 *.sysd vrn search - from the results, look for the pathname of recently uploaded
firmware file
7 *.sysd vrn install [pathname of the .tgz file]
ex: *.sysd version install /media/hd0/EN-20-v1.00.12.nfcms.tgz