Adtec digital EN-30 (version 1.02.02) Manual - Manual (Page 36)

How to Connect via Telnet
* Using Telnet (standard 23 port)* To connect to your device using a terminal session, you
will need to set the IP address of the unit. See earlier instructions on setting the IP via the
front panel.
Using a terminal window, complete the following:
Step Action
1 Type 'telnet x.x.x.x' in a terminal window, without quotes, where x.x.x.x is the IP
address of the unit.
2 Press .
3 When prompted for a username, enter adtec.
4 When prompted for a password, enter none.
Once you see "User 'adtec' connected", the session is open and you may issue API
commands to the unit.
For the EN-30 device, there are specific commands for the modulator, encoder, and the
unit's operating system. Each has a unique way of accepting commands. If using telnet is
your preferred method of communication to your device, familiarize yourself with the API
commands and their respective command handlers. For more information on this, point your
browser to the IPA of your unit and look through the API notes that are described for the
device.