Signamax Model -065-7700 - Manual (Page 183)

Hardened Managed PoE Ethernet Switch
User’s Manual 182
To restore to the default value, use the no ip igmp
query-max-response-time command.
3.
Command Syntax:
ip igmp query-max-response-time RESPONSETIME
no ip igmp query-max-response-time
RESPONSETIME <1-240> Maximum response time (in seconds)
advertised in IGMP queries. Default: 10 seconds.
4.
Example:
The following example configures a maximum response time of 8 seconds on
vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip igmp query-max-response-time 8
switch_a(config-if)#
IGMP passive snooping:
Static mc router port:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if)#
2.
Usage:
Use ip igmp snooping mrouter interface command to statically configure
the specified VLAN constituent interface as a multicast router interface for
IGMP Snooping in that VLAN.
Use the no ip igmp snooping mrouter interface command to remove the
static configuration of the interface as a multicast router interface.
3.
Command Syntax:
(no) ip igmp snooping mrouter interface IFNAME
IFNAME Specify the name of the interface
4.
Example:
The following example shows interface fe1 (port 1) statically configured to be
a multicast router interface on vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip igmp snooping mrouter interface fe1
switch_a(config-if)#