Signamax Model -065-7700 - Manual (Page 136)

Hardened Managed PoE Ethernet Switch
User’s Manual 135
3.
Command Syntax:
poe fixed-power-limit LEVEL
LEVEL <1-15.4> specifies the fixed power limit (Watts) for this port to provide
power to PD.
4.
Example:
The following example sets new fixed power limit 15 Watts to the interface
fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe fixed-power-limit 15
switch_a(config-if)#
Power Priority:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use this command to specify the power priority to this port.
3.
Command Syntax:
poe power-priority PRIORITY
PRIORITY specifies high, medium, low power priority for this port.
4.
Example:
The following example sets high power priority to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#poe power-priority high
switch_a(config-if)#
Power Down Alarm:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#