Signamax Model -065-7700 - Manual (Page 169)

Hardened Managed PoE Ethernet Switch
User’s Manual 168
3.
Command Syntax:
snmp-server community get NAME
no snmp-server community get
NAME The get community name for SNMP.
4.
Example:
The following example specifies get community name (name) for SNMP:
switch_a(config)#snmp-server community get name
switch_a(config)#
Set Community Name:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use snmp-server community set command to specify and no
snmp-server community set command to remove set community name for
SNMP.
3.
Command Syntax:
snmp-server community set NAME
no snmp-server community set
NAME The set community name for SNMP.
4.
Example:
The following example specifies set community name (name) for SNMP:
switch_a(config)#snmp-server community set name
switch_a(config)#
SNMP v3
SNMPv3 No-Auth:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Add a user using snmp v3 with read-only or read-write access mode and
without authentication. Use the no form of the command to delete this user.
3.
Command Syntax: