Signamax Model -065-7700 User Manual
Page 133
Hardened Managed PoE Ethernet Switch
User’s Manual 132
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to statically configure a bridge entry to forward matching
frames.
3.
Command Syntax:
bridge GROUP address MAC forward IFNAME VLANID
no bridge GROUP address MAC forward IFNAME VLANID
GROUP <1-1> Bridge-group ID used for bridging.
MAC the Media Access Control (MAC) address in the HHHH.HHHH.HHHH
format.
IFNAME the interface on which the frame comes in.
VLANID The VID of the VLAN that will be enabled or disabled on the bridge
<2-4094>.
4.
Example:
The following example configures a bridge GROUP (1) to forward matching
frames (MAC address 2222.2222.2222) to the interface fe1 (port 1) in vlan
VLANID (2):
switch_a(config)#bridge 1 address 2222.2222.2222 forward fe1 vlan 2
switch_a(config)#
Static-MAC-Entry Discard:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to statically configure a bridge entry to discard matching
frames in a particular VLAN.
3.
Command Syntax:
bridge GROUP address MAC discard vlan VLANID
no bridge GROUP address MAC discard vlan VLANID
GROUP <1-1> Bridge-group ID used for bridging.
MAC the Media Access Control (MAC) address in the HHHH.HHHH.HHHH
format.
VLANID The VID of the VLAN on the bridge <1-4094>.
4.
Example:
The following example configures a bridge GROUP (1) to discard matching
frames (MAC address 2222.2222.2222) in vlan VLANID (1):