Signamax Model -065-7700 - Manual (Page 101)

Hardened Managed PoE Ethernet Switch
User’s Manual 100
Command Line Console Management
The switch provides a command line console interface for
configuration purposes. The switch can be configured either
locally through its RS-232 port or remotely via a Telnet
session. For the later, you must specify an IP address for the
switch first.
This chapter describes how to configure the switch using its
console by Commend Line.
Administration Console
Connect the DB9 straight cable to the RS-232 serial port of the device to the
RS-232 serial port of the terminal or computer running the terminal emulation
application.
Direct access to the administration console is achieved by directly connecting
a terminal or a PC equipped with a terminal-emulation program (such as
HyperTerminal) to the switch console port.
When using the management method, configure the terminal-emulation
program to use the following parameters (you can change these settings after
login):
[Default parameters]
115,200bps
8 data bits
No parity
1 stop bit