Signamax Model -065-7700 - Manual (Page 168)

Hardened Managed PoE Ethernet Switch
User’s Manual 167
Use snmp-server trap-type enable authenticationFailure command to
enable authentication failure trap for SNMP.
Use the no snmp-server trap-type enable authenticationFailure
command to disable authentication failure trap for SNMP.
3.
Command Syntax:
(no) snmp-server trap-type enable authenticationFailure
4.
Example:
The following example enables authentication failure trap for SNMP:
switch_a(config)#snmp-server trap-type enable authenticationFailure
switch_a(config)#
Topology Change Trap:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use snmp-server trap-type enable topologyChange command to enable
topology change trap for SNMP.
Use the no snmp-server trap-type enable topologyChange command to
disable topology change trap for SNMP.
3.
Command Syntax:
(no) snmp-server trap-type enable topologyChange
4.
Example:
The following example enables topology change trap for SNMP:
switch_a(config)#snmp-server trap-type enable topologyChange
switch_a(config)#
SNMP v1/v2c
Get Community Name:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use snmp-server community get command to specify and no
snmp-server community get command to remove get community name for
SNMP.