Signamax Model -065-7700 - Manual (Page 146)

Hardened Managed PoE Ethernet Switch
User’s Manual 145
Use the no spanning-tree link-type command to set a port to its default
state and to disable rapid transition.
3.
Command Syntax:
(no) spanning-tree link-type LINKTYPE
LINKTYPE The link type to be assigned to the port.
point-to-point Enable rapid transition.
shared Disable rapid transition.
4.
Example:
The following example sets the link-type LINKTYPE (point-to-point) of the
interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree link-type point-to-point
switch_a(config-if)#
Autoedge:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use spanning-tree autoedge command to assist in automatic identification
of the edge port.
Use the no spanning-tree autoedge command to disable this feature.
3.
Command Syntax:
(no) spanning-tree autoedge
4.
Example:
The following example enables the spanning-tree autoedge of the interface
fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#spanning-tree autoedge
switch_a(config-if)#
Edgeport:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.