Paxton Superchargers Ford Mustang GT User Manual

Page 84

P/N: 4809654 v5.0

15. FiNAL CHECk

*** NOTE ***

Do not attempt to operate the vehicle until all compo-

nents are installed and all operations are completed

including the final check.

A. If your vehicle has gone over 15,000 miles

since its last spark plug change, you will need

to change the spark plugs now before test driv-

ing the vehicle.

B. Check all fittings, nuts, bolts and clamps for

tightness. Pay particular attention to oil and fuel

lines around moving parts, sharp edges and

exhaust system parts. Make sure all wires and

lines are properly secured with clamps or tie-

wraps.

C. Check all fluid levels, making sure that your

tank(s) is/are filled with 91 octane or higher

fuel before commencing test drive.

D. Start engine and allow to idle a few minutes,

then shut off.

E. Recheck to be sure that no hoses, wires, etc. are

near exhaust headers or moving parts and for

signs of any fluid leakage.

(Novi SL equipped applications: secure the

remote drain hose away from the belt and hoses

using tie-wraps.)

F. PLEASE TAKE SPECIAL NOTE: Operating

the vehicle without ALL the subassemblies

completely and properly installed may cause

FAILURE OF MAJOR COMPONENTS.

G. Test drive the vehicle.
H. Always listen carefully for engine detonation.

Discontinue heavy throttle usage if detonation

is heard.

I. Read the STREET SUPERCHARGER

SYSTEM OWNER'S MANUAL AND

RETURN THE WARRANTY

REGISTRATION FORM within thirty (30)

days of purchasing your supercharger system to

qualify.

FoR iNTERNALLy LUBRiCATED

Novi SL UNiTS oNLy

This supercharger has been factory pre-filled with

special Paxton synthetic lubricant. Oil does not

need to be added to a brand new unit; however, a

fluid level check should be performed.

Prior to operating the supercharger on the vehicle

and after installation onto the vehicle:

Remove the factory installed flat-head brass ship-

ping plug (not the dipstick) from the top of the

supercharger case. Replace the sealed shipping

plug with the supplied “vented” plug. Do not oper-

ate the supercharger without it. Check the super-

charger fluid level.

Fluid level checking procedure:

1. Ensure that the .06" copper sealing washer is

located on the dipstick base.

2. Thread the clean dipstick into the unit until it

seats.

3. Once the dipstick has seated, remove the dipst-

fick from the unit. Fluid should register in the

crosshatched area on the dipstick

4. DO NOT OVERFILL!!! Drain excess fluid

from the unit if it is above the maximum level

on the dipstick.

Check the fluid level using the dipstick at least every

2,500 miles.

Initial supercharger fluid change must be per-

formed at 2,500 miles. The supercharger fluid must

be changed at least every 7,500 miles.

Drain the fluid, re-fill the unit with 4oz of

Paxton SL lubricating fluid and then confirm

proper oil level using the dipstick. Do NoT

ovERFiLL!!!

*** NOTE ***

Use of any fluid other than the special Paxton sup-

plied lubricating fluid will void the warranty and may

cause component failure.

Section 9

AIR DISCHARGE ASSEMBLY INSTALLATION

(NON-COOLED KITS ONLY)