Preparation/removal – Paxton Superchargers Ford Mustang GT User Manual

Page 43

P/N: 4809654 v5.0

*** NOTE ***

For non-cooled kits skip this section and proceed to

Section 9.

8A. BUMPER CovER AND SPLASH PAN (H.o.

kits only)
1. Raise the vehicle with a floor jack and set

on jack stands.

2. Remove the seven 5.5mm headed screws

retaining the lower splash panel. (See Fig.

8A-a.)

3. Remove the six Phillips-head screws (3

each side) on the lower portions of the

plastic inner fender liners. (See Fig. 8A-b.)

4. Remove the five plastic clips retaining the

front portion of the fender liner. Both sides

need to be removed. (See Fig. 8A-c.)

5. Remove the four 10mm nuts (2 each side)

retaining the bumper cover to the fenders.

(See Fig. 8A-d.)

Fig. 8A-a

Fig. 8A-b

Fig. 8A-c

Fig. 8A-d

10mm HEADED

BOLTS

PHILLIPS-

HEAD

SCREWS

SPLASH

PANELS

Section 1

PREPARATION/REMOVAL