Paxton Superchargers Ford Mustang GT User Manual

Page 32

P/N: 4809654 v5.0

Fig. 5.1-e

Fig. 5.1-f

G. Locate the supplied 1-1/4" expansion plug

(7P125-002.)

H. Coat the expansion plug with sealant. Using a

tube or socket that matches the recessed diame-

ter of the plug, install the plug flush with the

machined surface sealing the outlet of the cross-

over tube. (See Figs. 5.1-e, 5.1-f.)

I. Locate the supplied coolant relocation fitting,

sealing nut and O-ring washer. (See Fig. 5

-g.)

J. Install the fitting in the location of the factory

coolant bleed plug. (See Fig. 5

-h.) Screw the

jam nut all the way onto the fitting. Tighten the

fitting in the position shown. (See Fig. 5

-h.)

Secure with the jam nut.

*** NOTE ***

It is recommended that sealant be used to seal the

thread of the fitting.

K. Reinstall the factory O-ring gaskets to the

crossover tube.

L. Set the coolant crossover tube back in its origi-

nal location.

M. Reinstall the two 10mm headed bolts through

the cross-over tube into the cylinder heads.

Temporarily install two intake manifold retain-

ing bolts through the cross-over tube into the

cylinder heads, where the manifold will be

secured. Leave these loose as they are there

only as a pilot for the cross-over tube.

Fig. 5.1-h

Fig. 5.1-g

FACTORY

COOLANT

BLEED LOCATION

REMOVE:

NOT

REUSED

RETAIN 90°

FITTING

5.1 CooLANT TUBE RELoCATioN, (2005-

2006 only)

cont’d