Paxton Superchargers Ford Mustang GT User Manual

Page 39

P/N: 4809654 v5.0

Fig. 6-f

Fig. 6-h

Fig. 6-g

*** NOTE ***

All kits will use the upper idler hole except for 2005-

2008 H.O. kits. (See Fig. 6-c.)

K. Tighten all mounting plate hardware, making

sure the drive belt is properly routed and no

wiring or hoses are between the mounting sur-

faces. (See Fig. 6-g.)

SUPERCHARGER

HARDWARE

.097"

SPACER

1.776"

SPACER

IDLER

PILOT

SPACER

I. Locate the 8mm x 150mm bolt and washer.

Loosely install the bolt through the mounting

plate and remaining 2.712" long spacer into the

engine cover using Fig. 6-a for location refer-

ence.

J. Locate the supplied idler, 1.776" idler spacer,

idler pilot spacer, 3/8-16 x 3.75" long bolt and

washer. Install the bolt/washer through the

mounting plate, 1.776" spacer, supplied idler,

idler pilot spacer and into the triangle-shaped

bracket. Use Figs. 6-f to 6-h for assistance.

M.* Attach the supplied length of 1/2" oil drain line

hose to the 1/2" barbed fitting on the super-

charger. Secure with the #8 hose clamp provid-

ed.

N.* Install the supplied 1/8"NPT x -4 straight fitting

from assembly 4FU130-026 to the oil feed fit-

ting on the supercharger.

*** NOTE ***

Use only clean engine oil on the pipe threads. Teflon

tape or pipe sealant is not recommended as if might

loosen and cause blockage of the small oil feed orifice

resulting in possible supercharger failure.

O. Attach the supercharger assembly to the mount-

ing plate using the previously installed hard-

ware. A 9/16" ratcheting end wrench will great-

ly aid this step.

P.* Secure the oil drain hose to the prevously

installed brass fitting in the oil pan, making

sure to route in a smooth downward manner

away from moving or hot objects.

*** NOTE ***

Any dips, “uphill” sections, kinks or restrictions may

cause drainage problems and possible supercharger

failure.

Q.* Attach the -4 oil feed hose to the straight -4 fit-

ting previously installed in the supercharger.

Secure away from moving of hot objects.

R. Using a 1/2" ratchet, rotate the factory spring

tensioner clockwise and install the accessory

drive belt. Refer to Fig. 6-e for proper belt rout-

ing.

Applies to engine “oil-fed” units only.

L. Install the five 3/8-16 x 1.0" bolts and washers

through the back side of the mounting plate.

(See Fig. 6-g.)

6. SUPERCHARGER MoUNTiNG PLATE

iNSTALLATioN,

cont’d