Preparation/removal – Paxton Superchargers Ford Mustang GT User Manual

Page 31

P/N: 4809654 v5.0

A. Locate assembly 4FU214-021.
B. Remove the hose connected to the back lower

portion of the engine coolant cross-over tube.

(See Fig. 5.1-a.)

C. Remove the nylon clip retaining the wire har-

ness to the alternator brace and the four 10mm

headed bolts securing the alternator brace. Set

the brace aside to be reinstalled. (See Fig. 5.1-

b.)

E. Remove the two remaining 10mm head bolts

securing the cross-over tube to the cylinder

heads.

F. Remove the factory O-ring type gaskets to pre-

vent damage. Clamp the driver’s side steel hose

barb end of the coolant cross-over tube in a vise

as shown. Using a small amount of heat, heat

the aluminum cross-over tube. Using a twisting

motion, remove the steel insert. (See Fig.

5.1-d.) Penetrating oil will also aid in this step.

5.1 CooLANT TUBE RELoCATioN (2005-

2006 oNLy)

Fig. 5.1-a

Fig. 5.1-b

Fig. 5.1-c

NYLON

ALIGNING CLIP

10mm HEADED BOLTS

HOSE

CONNECTION

BLEED PLUG

DRIVER’S SIDE

HOSE

CONNECTION

Section 1

PREPARATION/REMOVAL