Paxton Superchargers Ford Mustang GT User Manual

Page 46

P/N: 4809654 v5.0

3. Using a 3" x 3" bump sleeve and two #48 hose

clamps, loosely attach tube “A” to the super-

charger discharge.

*** NOTE ***

The by-pass port should be facing the driver’s side

4. Attach tube “B” using a second 3" x 3" bump

sleeve and the provided #48 hose clamps to the

open end of tube “A”.

*** NOTE ***

For better duct clearance, rotate the power steering

return fitting so that it points to the front of the vehicle.

Use care not to damage the fitting or hose. If neces-

sary, rotate the power steering line from the rack to

the radiator closer to the frame. (See Fig. 8B-d.)

8B. CHARGE AiR CooLER CoRE

iNSTALLATioN (2005-2006 Model H.o. kits

only)

Fig. 8B-c

Fig. 8B-d

SHORT ENDS OF 90°

ELBOWS PROVIDED

FITTING ROTATED

TOWARD

FRONT OF VEHICLE

*** NOTE ***

Use Fig. 8B-a to aid in the next few steps

1. Locate the Charge Air Cooler assembly.

Place the cooler onto the previously

installed hardware, making sure the four

spacers remain in place. Align the top of

the cooler flush with the top of the styro-

foam bumper support. Secure the cooler

using the nuts and washers provided. (See

Fig. 8B-b.)

2. Loosely install the short ends of the two

90° rubber elbows onto each end of the

charge cooler using the supplied #48 hose

clamps. (See Fig. 8B-c.)

Fig. 8B-a

Fig. 8B-b

TUBE

“A”

TUBE

“B”

TUBE

“C”

TUBE “D”

TUBE “E”

DISCHARGE DUCT

CHARGE

COOLER

FLUSH WITH TOP