Paxton Superchargers Ford Mustang GT User Manual

Page 54

P/N: 4809654 v5.0

8G. CHARGE AiR CooLER CoRE iNSTALLATioN

(2007-2010 Model H.o. kits only)

Fig. 8G-c

Fig. 8G-d

SHORT ENDS OF 90°

ELBOWS PROVIDED

FITTING ROTATED TOWARD

FRONT OF VEHICLE

*** NOTE ***

Use Fig. 8G-a to aid in the next few steps

1. Locate the Charge Air Cooler assembly.

Place the cooler onto the previously

installed hardware, making sure the four

spacers remain in place. Align the top of

the cooler flush with the top of the styro-

foam bumper support. Secure the cooler

using the nuts and washers provided. (See

Fig. 8G-b.)

2. Loosely install the short ends of the two

90° rubber elbows onto each end of the

charge cooler using the supplied #48 hose

clamps. (See Fig. 8G-c.)

3. Using the Ø3" x 2.75" reducer sleeve and

clamps, loosely attach tube “A” to the

supercharger’s discharge. (See Fig. 8G-e.)

Fig. 8G-a

Fig. 8G-b

FLUSH WITH

TOP

TUBE

“A”

TUBE

“E”

TUBE

“D”

DISCHARGE

DUCT

TUBE

“C”

*** NOTE ***

For better duct clearance, rotate the power steering return fitting so

that it points to the front of the vehicle. Use care not to damage the

fitting or hose. If necessary, rotate the power steering line from the

rack to the radiator closer to the frame. (See Fig. 8G-d.)