NEXCOM OPPC 1520T - Manual (Page 78)

Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 63
Chapter 3: System Setup
OPPC 1520T/1720T User Manual
334
261
167
130.500
7 max.
Panel Mounting
1. Select a place on the panel where you will mount the Panel PC.
2. Cut out a shape on the panel that corresponds to the Panel PC’s rear
dimensions.
The thickness of the panel (e.g. steel board, plank, acrylic board, wall,
etc.) where you will mount the Panel PC must not exceed 7mm. If the
distance between the front bezel and panel mount hole is too wide, it
will not fit the panel mount kit.
OPPC 1520T
OPPC 1720T
3. Slide the Panel PC through the hole until it is properly fitted against the
panel.
7 max.
334
167
130.50
261
366
304.200
183
152.100
7 max. 7 max.
366
183
304.20
152.10