NEXCOM OPPC 1520T User Manual

Page 60

Text mode
Original mode

Chapter 3: System Setup

OPPC 1520T/1720T User Manual

3. Insert the module into the socket at an approximately 30 degrees

angle. Apply firm even pressure to each end of the module until it slips
into the socket. The gold-plated connector on the edge of the module
will almost completely disappear inside the socket.

SODIMM

4. Push the module down until the clips on both sides of the socket lock

into position. You will hear a distinctive “click”, indicating the module
is correctly locked into position.

Clip

This manual is related to the following products:

OPPC 1720T