Manually add unit, Using the internally stored dugan control panel – Dan Dugan Sound Design Dugan-VN16 User Manual
Page 41
Dugan-VN16 User Guide
Configuration
41
Manually Add Unit
If the Dugan unit does not appear in the Dugan Utility list pane, you can manually
add the unit:
1. Hold down the rear panel NETWORK RESET button for three seconds.
This generates an IP address.
2. Click Manually Add Unit.
3. Enter the generated IP address: 192.168.1.xx
xx = last two digits of serial number, unless they are 00, in which case enter 100.
4. Click OK to exit the dialog.
5. Click Refresh List.
If the list pane is still blank, see Using the Internally Stored Dugan Control Panel below.
If the unit appears in the list, go to step 4 on page 39.
Using the Internally Stored Dugan Control Panel
Normally, the Dugan Control Panel is run from the Dugan-Control-Panel-vxxx.jar
file. However, if for any reason you do not have that file or an Internet connection,
you can run the Dugan Control Panel from a copy stored in the unit (see Chapter 5:
Updates
.
It is not currently possible to run the internally stored Dugan Control Panel from an iPad.
To run the internally stored Dugan Control Panel:
1. Launch your browser.
2. Enter the IP Address of the unit.
3. If you do not know its IP Address, press and hold the rear panel NETWORK RESET
button for 3 seconds.
The IP Address will be set to 192.168.1.xx (xx = last two digits of the unit’s serial
number, unless 00, then use 100).
4. Enter this IP address in your browser’s address bar.
5. If the Top Pane of the Dugan-VN16 control panel is empty, open a separate brows-
er tab for each unit you wish to operate, and enter its IP Address. Switch units by
clicking different tabs.
If this does not work, consult the duganusers Yahoo group (
or contact Dan Dugan Sound Design.
iPad