J6 j5 – Dan Dugan Sound Design Dugan-VN16 User Manual

Page 26

Dugan-VN16 User Guide

7. When viewing the cards from the front of FOH Rack, attach the right-most con-

nector of the top card to the left-most connector (J6) of the Dugan-VN16 card.

Make sure the keyed connector is oriented correctly in each socket. Secure each
connection by moving the tabs on each side of the connector inward. Check to
make sure the cables are connected securely.

8. Attach another cable between the two connectors shown in Figure 2-25.

Figure 2-25 Ribbon cables connecting the Dugan-VN16 card to the I/O card

NOTE:

To simplify connecting the ribbon cables, you may wish to disconnect the ribbon cable
attached to the blue connector of the FOH IO card before attaching the cables to the Du-
gan-VN16. Remember to re-connect this cable after connecting to the Dugan-VN16.

9. Plug an available power connector from the FOH Rack into the power socket on

the Dugan-VN16 card. Make sure it is connected securely.

Figure 2-26 Dugan-VN16 card power connector

Dugan-VN16 card
power connector