Dan Dugan Sound Design Dugan-VN16 User Manual
Page 16
Dugan-VN16 User Guide
16
3. Disconnect the 50-pin ribbon cable from the port on the card by moving the tabs
on each side of the connector outward. Leave the other end of the cable connected.
Figure 2-7 Disconnecting ribbon cable from the output card in slot D
4. On the back of the console, remove the four screws that secure the card to the con-
sole and gently slide the card out of the console. Set the card and the screws aside.
You will reinstall the output card after you install the Dugan-VN16 card.
To remove the slot E cover or the output card in slot E:
1. Inside the console, locate the Hub 48 card and its five I/O card ports (Figure 2-8).
Disconnect the ribbon cable connected to the back port (J1 Slot E on the Hub48
card). The other end of this cable is connected to either the slot E cover, or to an
output card (if you installed an AO16 or IO16 card). This cable will be removed
from the console entirely.
Figure 2-8 The Hub48 card and its five I/O card ports
Hub48 card
J1 Slot E