Dan Dugan Sound Design Dugan-VN16 User Manual
Page 17
Dugan-VN16 User Guide
Installation
17
2. On the back panel of the SC48, locate output slot E.
Figure 2-9 Left side of the SC48 back panel
3. Do one of the following depending on your configuration:
•
Remove the four screws holding the card slot cover in place. After removing the
screws, you can use a flathead screwdriver to pry the cover away from the slot. Re-
move the ribbon cable that is attached to the slot cover.
- or -
•
If you installed an additional output card in slot E, remove the four screws secur-
ing the card to the console and gently slide the card out of the console. Remove
the attached ribbon cable along with the card.
Installing the Dugan-VN16 card:
1. Inside the console, locate the Main I/O card (under the now-removed output
cards), and connect the two included ribbon cables to the ports J28 and J29
(Figure 2-10).
Figure 2-10 Main I/O card in SC48 and the ribbon cable ports
Slot E (remove cover or output card (if present)
Main I/O card
Port J28
Port J29