Dan Dugan Sound Design Dugan-VN16 User Manual
Page 18
Dugan-VN16 User Guide
18
Make sure the keyed connector is oriented correctly in each socket. Secure each
connection by moving the tabs on each side of the connector inward. Check to
make sure the cables are connected securely.
NOTE:
You will connect these cables to the Dugan-VN16 card, so make sure they are easily ac-
cessible after you slide the Dugan-VN16 card into the console.
2. Route the two ribbon cables that you connected to the Main I/O card next to the
right-inner wall of the chassis. Position the cables as shown below in Figure 2-11 (so
that the cable connected to port J28 is on top of the cable connected to port J29).
Figure 2-11 Routing the ribbon cables next to the chassis wall (viewed from right side of SC48)
3. Remove the Dugan-VN16 card from its packing material. Hold the card by its edges.
Figure 2-12 Dugan-VN16 card showing connectors
Power connector port
J6
J5