Dan Dugan Sound Design Dugan-VN16 - Manual (Page 21)

Dugan-VN16 User Guide Installation
21
To reinstall an output card in slot D and close the Top Panel:
1. Slide the output card gently into slot D, and secure it to the back of the console
using the four screws you removed earlier.
2. Inside the console, reconnect the 50-pin ribbon cable to the card that you discon-
nected in step 3 on page 16.
Figure 2-16 Reconnecting the ribbon cable on the output card
3. Tighten the two captive thumbscrews to secure the card to the inside of the console.
4. Loosen the two interior captive thumbscrews holding the Top Panel upright, and
gently lower the Top Panel into position.
NOTE: The Top Panel has slots that pivot on posts attached to the sides of the console chassis.
When lowering the Top Panel, the Top Panel slots may not stay correctly aligned with the
posts. Gently slide or push the Top Panel towards the rear of the console while lowering,
making sure the posts are correctly aligned with the slots. This way, the Top Panel screw
holes align with console chassis screw holes.
5. To secure the Top Panel to the console chassis, locate the Torx or hex screws that
you removed originally and reinstall them.