CIRCUTOR CIRLAMP Series User Manual
Page 60
On this screen,
, you can configure all of the parameters required to send the email:
mailHost: IP address of the server where the reports will be sent.
mailUser: Username for the server to which the reports will be sent.
mailPassword: Password for the server to which the reports will be sent.
mainMail: IP address of the server where the reports will be sent.
destinationMail: Email address where the reports will be sent.
shows an example of the report sent via email when burnt-out lamps are detected.
*****************************
CirLamp Manager
*****************************
Installation status:
NodeId: 1000000 -> broken
NodeId: 5000005 -> broken
NodeId: 1300000001 -> broken
NodeId: 1301250006 -> broken
NodeId: 1301316033 -> broken
NodeId: 1301316039 -> broken
NodeId: 1301316043 -> broken
NodeId: 1301316044 -> broken
NodeId: 1301316045 -> broken
NodeId: 1301316047 -> broken
*****************************
Figure 64: Report via email�
4.6.10.6. Node communications configuration
Figure 65:Node communications configuration
On this screen,
Figure 62
, you can configure all of the parameters required to adjust the com-
munications with the nodes:
priority: You can select to enable or disable the priorities assigned to the tasks in the
case of a collision..
timeSendReq: Maximum time to send a report.
timeDisconNode: Time in which the unit changes from status
A
(Active)
to
PF
(per-
manent fault).
retryDisconNode: Retries at communications with a node.
timeRetryinterval: Time between retries at communications with a node, in seconds.
valuesCheckDelay: Minimum time between an order and a reading, in seconds.
60
CirLAMP system
Instruction Manual