CIRCUTOR CIRLAMP Series User Manual
Page 59

4.6.10.3. NTP configuration
Figure 61:NTP configuration.
On this screen you can configure the following configuration parameters for the NTP:
ipNtp: IP address for NTP synchronisation.
ntpMaxDeviation: Time deviation to create an event, in seconds.
4.6.10.4. FTP configuration
Figure 62:FTP configuration.
On this screen you can set up the following configuration parameters for the FTP:
ipFtp: IP address for the server to which the reports will be sent.
ftpUser: Username for the server to which the reports will be sent.
ftpPwd: Password for the server to which the reports will be sent.
pathReports: Server path to where the reports are sent.
retryFtp: Number of retries for accessing the FTP server.
timeBetwFtp: Time between retries for accessing the FTP server, in seconds.
FtpServer: FTP server.
FtpsServer: FTP server on TLS.
4.6.10.5. Mail configuration
The unit can send a report via email when a node alarm is activated.
Figure 63:Mail configuration.
59
Instruction Manual
CirLAMP system