CIRCUTOR CIRLAMP Series - Manual (Page 57)

Each of the eight outputs of a module can be assigned to:
 Sunset: when the sun goes down.
 Sunrise: when the sun comes up.
 In1 ��� In8: the status of the selected input.
NB: An output may have more than one option assigned; in this case the output will switch to
ON status when any of the options are fulfilled.
The Sinc� Node column is used to indicate whether we want the units configured with time slots
to synchronise when the selected input is activated.
Offset configuration:
If an output has been assigned to Sunset or Sunrise, in this section you can program:
 OffsetOrto: Time in minutes between sunrise and the activation of the assigned out-
put.
 OffsetOcaso: Time in minutes between sunset and the activation of the assigned out-
put.
4�6�10� CirLAMP MANAGER MENU: PARAMETERS
From this screen you can display and configure all of the unit's parameters.
4�6�10�1� General parameters
The general parameters of the CirLAMP Manager are factory-set and cannot be modified from
the web site.
Figure 59:General parameters�
57 Instruction Manual
CirLAMP system