Delta Electronics Ethernet Communication Module IFD9507 - Manual (Page 22)

Ethernet Communication Module IFD9507
DVP-PLC Application Manual 20
Object Name Class ID Code Instance Code
Function
Description
Object Type Attribute
TCP Link 0xF6 0x01 TCP/IP Link
Object Object Get
9.3 CIP General Status Code (Reference Volume 1:CIP Common Specification Appendix B)
General
Status Code
(in hex)
Status Name Description of Status
00 Success Service was successfully performed by the object specified.
01 Connection failure A connection related service failed along the connection path.
02 Resource unavailable Resources needed for the object to perform the requested
service were unavailable
04 Path segment error The path segment identifier or the segment syntax was not
understood by the processing node. Path processing shall stop
when a path segment error is encountered.
05 Path destination
unknown
The path is referencing an object class, instance or structure
element that is not known or is not contained in the processing
node. Path processing shall stop when a path destination
unknown error is encountered.
08 Service not supported The requested service was not implemented or was not
defined for this Object Class/Instance.
09 Invalid attribute value Invalid attribute data detected
0E Attribute not settable A request to modify a non-modifiable attribute was received.
13 Not enough data The service did not supply enough data to perform the
specified operation.
14 Attribute not supported The attribute specified in the request is not supported
15 Too much data The service supplied more data than was expected
16 Object does not exist The object specified does not exist in the device.
20 Invalid parameter A parameter associated with the request was invalid. This code
is used when a parameter does not meet the requirements of
this specification and/or the requirements defined in an
Application Object Specification.
26 Path Size Invalid The size of the path which was sent with the Service Request
is either not large enough to allow the Request to be routed to
an object or too much routing data was included.
9.4 Connection Manager Service Request Error Codes (Reference Volume 1:CIP Common Specification
Table3-5.29)
General
Status
Extended Status Explanation and Description
0x00 Service completed successfully
0x01 0x0100 CONNECTION IN USE OR DUPLICATE FORWARD OPEN
This extended status code shall be returned when an originator is
trying to make a connection to a target with which the originator may
have already established a connection
0x01 0x0103 TRANSPORT CLASS AND TRIGGER COMBINATION NOT
SUPPORTED
A transport class and trigger combination has been specified which
is not supported by the target. Routers shall not fail the connection
based on the transport class and trigger combination. Only targets
shall return this extended status code.
0x01 0x0108 INVALID NETWORK CONNECTION PARAMETER
This extended status code shall be returned as the result of
specifying a connection type, connection priority, redundant owner
or fixed / variable that is not supported by the target application.
Only a target node shall return this extended status code.