Pilz PMCprimo DriveP.12/AA0/4/0/0/208-480VAC - Manual (Page 12)

8 Use
8.3.1 Title bar
The program name and the name of the currently opened document are displayed in the title
bar.
Furthermore the connection status will be shown ("connected" or "not connected").
8.3.2 Menu bar
File
New Creates a new parameter file.
Open... Opens a parameter file: A parameter data set is read from the
data medium (hard drive, floppy disk). If there is an active
connection, the data set is downloaded to the servo amplifier.
Save parameters Saves the current parameter data set to a data medium (hard
disk, diskette) while keeping the file name, if the data set already
has a name. If the data set has not yet got a name, you will be
prompted to enter a name and storage location.
Save parameters as... Saves the current parameter data set to a data medium (hard
disk, diskette). You will be prompted to enter a name and storage
location.
Export as FB for
SoftPLC Exports the actual parameters into a EXP file. This file can be
imported in the windows program CoDeSys for a Software-PLC.
Print... The current data set will be printed out. You can choose whether
the print data are sent to the system printer or saved to a file.
Print preview /
Print setup... Use these functions in the same way as for any other Windows
software.
Send... Sends the actual data file via E-mail.
Exit Terminates the program.
Communication
Connect / Disconnect
PC
↔ amplifier
Connect or disconnect PDrive and servo amplifier.
Save parameters to
EEPROM Saves the current parameter data set permanent in the EEPROM
of the servo amplifier.
Load default
parameters to RAM /
EEPROM Reset all parameters and load the default parameters to RAM /
EEPROM.
View
Toolbar
Status bar
Service bar Switch to show/hide the toolbar (above) or the service bar and
status bar (below).
Programs
PTerm
PScope
PEdit
PMotion
primoFTP Starts the tools PTerm (terminal program) ,PScope (scope
function), PEdit (text editor), PMotion (motion generator) or
primoFTP (PMCprimo FTP program).
Page 12 User Manual for Setup Software PDrive