Pilz PSSu H CAN - Manual (Page 19)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-5
4.3 USB port
4 Function description
4.3 USB port 4300 USB port 4- ][Funktion_BA_Zusatz USB
The following functions are available via the USB port:
 Show actual hardware
 Comparison of actual/registered hardware
 Display and update firmware versions
 Setting the parameters for the ST section
Parameters for the module's ST section can either be set via the fieldbus
interface or via the USB port. Parameter setting via the USB port has pri-
ority over parameter setting via the fieldbus interface. Once parameters
for the the head module have been set via the USB port, the ability to set
parameters for the module via the fieldbus interface is disabled. The dis-
able can be lifted in the PSSuniversal Assistant.
Procedure for connecting the head module via the USB port:
 Connect PC to head module via USB cable.
 Install USB driver.
 View the actual hardware registry in the PSSuniversal Assistant and
call up other functions.
This way it is possible to copy and edit an existing configuration in the
PSSuniversal Assistant.
INFORMATION
The USB driver can be found on the PSSuniversal Assistant
CD-ROM, in the subdirectory \bin\PILZ_USB_DRIVER