Pilz PNOZ mmc6p CAN - Manual (Page 19)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-1
6.1 Wiring
6 Commissioning
6 6000 Commissioning Commissioning 6- 6.1 Wiring 6100 Wiring 6- 6.1.1 General wiring guidelines
General wiring guidelines 6- Verdrahtung_multi_Modul
The wiring is defined in the circuit diagram of the PNOZmulti Configura-
tor.
Note:
 Information given in the "Technical details" must be followed.
Verdrahtung_Montageschiene mit Schutzerde verbinden  Always connect the mounting rail to the protective earth via an earth-
ing terminal. This will be used to dissipate hazardous voltages in the
case of a fault.
Verdrahtung_Netzteil_sichere_Trennung  The power supply must meet the regulations for extra low voltages
with safe separation.
Verdrahtung_multi_Achtung_Kabel_spannungsl_ziehen_Modul
Verdrahtung_multi_Feldbus_Hinweis Nutzerorg_CANopen
6.1.2 Connecting the supply voltage
Connecting the supply voltage 6- Verdrahtung_multi_Feldbus_Versorgungsspannung_Mini
Connect the supply voltage to the fieldbus module:
 Terminal 24 V: + 24 V DC
 Terminal 0 V: 0 V
CAUTION!
Only connect and disconnect the expansion module when the
supply voltage is switched off.
NOTICE
When installing, you must refer to the guidelines published by
the CANopen User Group (CiA).